Shop headings: New Spares | Used Spares | Accessories | Brands
Coil clamp for round 12 volt coils
2 required per bike. No longer available new, call us to order used coil clamps
Sorry, this part is no longer available.
Sorry this item is out of production
Old type 4 pin starter relay in metal case. Note that this has two large terminals and two smaller ones, depending on model you may need to fit wider spade connectors to fit this relay. See ELA10003 for large female spade connectors
This part is due back in stock soon, call 01484 841395 to reserve yours
12732500 GU12732500 12 73 25 00
1273 2500 1273.2500 12.73.25.00
£30.90
INC VAT
£25.75 EX VAT
Dimensions:
40mm diameter body x 140mm overall (Length may sometimes vary slightly depending upon supplier).
12 volt single lead ignition coil
Suitable for points and Motoplat equipped big twins. NB models with Digiplex ignition use ELA30716. HT lead screws into this HT lead
This part is due back in stock soon, call 01484 841395 to reserve yours
14716502 GU14716502 14 71 65 02
1471 6502 1471.6502 14.71.65.02
Also fits Ducati, MZ ETZ 250/251
£44.00
INC VAT
£36.67 EX VAT
Rectifier / diode board for Bosch charging systems. High quaility replacement part sourced from Germany
See our Bosch fault finder page for help diagnosing problems on your Bosch charging system.
This part is due back in stock soon, call 01484 841395 to reserve yours
17704300-z 17704300 GU17704300 17 70 43 00
1770 4300 1770.4300 17.70.43.00
£95.00
INC VAT
£79.17 EX VAT
3 pin plastic connector for headlight bulb spade connections
No longer available from Guzzi
Sorry, this part is no longer available.
17740364 GU17740364 17 74 03 64
1774 0364 1774.0364 17.74.03.64
Sorry this item is out of production
Kit containing two replacement 60cm silicon HT leads, lead ends and 90° plug caps. The leads are suppied as a single double length lead so you can cut it into two leads of the exact required length. Includes crimp on lead ends for standard big twin 12v round coils
Suitable for most models with coils under the tank where the HT lead is not moulded into the ignition coil. We recommend checking what type of plug cap you have and measuring your existing cable run to check this part will fit
This part is due back in stock soon, call 01484 841395 to reserve yours
£28.00
INC VAT
£23.33 EX VAT
Motoplat ignition unit for one cylinder (2 required per bike)
Also known as Guzzi ref. 23721493, 27721435, 23721491, 23721490, 27721435
This part is available by special order, request a quote
23721494 GU23721494 23 72 14 94
2372 1494 2372.1494 23.72.14.94
£145.00
INC VAT
£120.83 EX VAT
Complete right hand Domino switchgear (starter and kill switch) plus twistgrip and pair of handlebar grips
Supplied with 4 pin Molex type connector. Use with ELA27015 to replace earlier Lego switch gear from Le Mans 2, T3 and V50 era models. No longer in production
Sorry, this part is no longer available.
27738815 GU27738815 27 73 88 15
2773 8815 2773.8815 27.73.88.15
Sorry this item is out of production
Brakelight switch for handlebar master cylinder
As this is longer available you may wish to fit BRA01004 instead
Sorry, this part is no longer available.
28741100 GU28741100 28 74 11 00
2874 1100 2874.1100 28.74.11.00
Sorry this item is out of production
Regulator rectifier for Saprisa charging systems
Male spade connectors on regulator, may be supplied with 7 connectors - see the diagram on our technical documents page for help installing this part. The standard black block connector is not compatible with the updated 7 pin reg/rec, you will instead need to fit female spade connectors to your wires.
This part is due back in stock soon, call 01484 841395 to reserve yours
28703800-z 28703800 GU28703800 28 70 38 00
2870 3800 2870.3800 28.70.38.00
£85.00
INC VAT
£70.83 EX VAT